Manually lighting the burners
1.Use a paper match to light the burners.
2.Push in and turn the burner knob to “LITE” for the burner closest to the lit match. The burner will light immediately. When burner is lit, turn knob away from “LITE” to desired setting
IMPORTANT:
If burner does not light immediately, turn the burner knob to “OFF” and wait 5 minutes before relighting.
If any burners do not light after attempting to manually light them, contact the KitchenAid Assistance Center.
Using the rotisserie
motor | rotisserie | rotisserie burner | |
spit rod | |||
| fork |
For best cooking results, do not use main grill burners when using the rotisserie.
The rotisserie system is designed to cook food from the rear using intense, searing infrared heat.
1.Remove warming shelf.
2.Mount rotisserie motor on the grill's mounting bracket. Position it securely into support bracket slots.
3.To load the spit rod, slide one of the rotisserie forks onto the spit rod with prongs facing away from handle.
4.Push spit rod through the center of the food, then slide second rotisserie fork into position.
5.Center the food and rotisserie forks on spit rod and tighten wing nuts on the rotisserie forks. If necessary, secure loose food portions with butcher's string only.
6.Once the food is positioned on spit rod, place pointed end of rod into rotisserie motor and lower spit rod onto supports at either side of the grill.
IMPORTANT: On Models KFGR292PSS, KFGR382PSS and KBGN292PSS, remove the handle from the spit rod
when using the side burner. The handle will
get “HOT” and failure to remove it will cause the
handle to crack and melt.
7.Plug
WARNING
Electrical Shock Hazard
Plug into a grounded
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
8.Plug
To avoid product damage when not using the rotisserie, remove motor and store indoors. Remove spit rod and forks. Store out of reach of children.
Lighting the rotisserie burner
1.Push in and turn rotisserie burner knob to “LITE”. You will hear a “snapping” sound.
2.Push the red button in.
3.When rotisserie burner lights, continue pressing the red button for another 5 to 10 seconds, and turn knob away from “LITE” to “HI”.
IMPORTANT:
If the rotisserie burner does not light immediately, turn the burner knob to “OFF”, wait 5 minutes before relighting.
Manually lighting rotisserie burner
1.Remove the manual lighting extension from inside the drip tray.
2.Attach a match to the clip.
3.Strike the match to light it.
4.Carefully hold the lit match close to the rotisserie burner.
5.Push in and turn the rotisserie burner control knob to “LITE”.
6.Push in the red button above the rotisserie burner control knob, the burner will light immediately. Hold this button in for 5 to 10 seconds, and turn
knob away from “LITE” to “HI”.
7.Replace manual lighting extension inside the drip tray.
IMPORTANT:
If the rotisserie burner does not light immediately, turn the rotisserie burner control knob to “OFF” and wait 5 minutes before relighting.
Using the smoker box
WARNING
Burn Hazard
Do not remove the smoker box when grill is hot.
Doing so can result in burns.
The smoker tray is designed for easy use. After deciding which wood chips to use, follow the instructions on wood chip packaging. Small size chips or pellets are recommended.
1.Slide box and chip cover out of smoker compartment.
2. Remove cover | chip cover |
| |
from box. Turn |
|
cover over and |
|
fill with | smoker box |
prepared | |
chips. |
|
3.Turn smoker box over and place over chip cover. Hold cover and box together and turn right side up.
4.Slide box and cover back into smoker compartment after lighting the smoker burner.
Light the smoker burner 5 minutes ahead of time to start it smoking. The specially- designed smoker will smoke the food while the grill burners or rotisserie cooks it. Keeping the hood closed as much as possible will maximize the smoking effect.
Lighting the smoker burner
1.Push in and turn smoker burner knob to “LITE”. You will hear a “snapping” sound.
2.When smoker burner lights, turn knob away from “LITE” to “HI”.
IMPORTANT:
If the smoker burner does not light immediately, turn the burner knob to “OFF”, wait 5 minutes before relighting.
13
