INSTALLING THE UNIT IN CABINET
Route electric supply cord so that it can be plugged into
receptacle after unit has been slid into place in cabinet.
Potential Personal Injury
l
Use both hands to remove oven doors.
l
Grasp only the sides of the oven door. Do Not use any
portion of the front frames or trim for lifting.
Failure to properly grasp oven door could result in
damage to product or personal injury.
The doors should be removed to decrease the weight of the
oven and provide a better hand hold on the oven while lifting
it into the cabinet.
A.
TO REMOVE
DOORS (See Illus.)
Use caution! Oven door is heavy.
1. Open door completely.
2. Depress finger tab in oven door hinge area. Push tab
toward oven. Lift tab away from door liner and slide toward
top of oven door.
3. Repeat step 2 for other side of door.
4. Close door until approximately 5 inches from fully closed
position.
5. Slide door off the hinge arm assemblies.
6. Repeat steps 1 through 5 for other door on double ovens.
BE SURE THAT
MICA SPACERS AT EITHER SIDE OF OVEN
ARE IN PLACE TO PROVIDE PROPER AIR FLOW BETWEEN
CABINET AND OVEN.
When oven has been placed into cabinet, the bottom trim strip
is placed on the lower edge of the front frame. This is done
by loosening the three screws at the bottom of the front frame.
Place gas valve extension rod through hole in trim strip and
slide strip under screw heads until the top edge of trim meets
the lower corners of the front frame (see Illus.). Tighten screws
to hold trim to front frame. Make sure that valve is turned to
the full “on” position (pin straight and down).
Personal Injury Hazard
Securely fasten wall oven to cabinets using the screws
provided (4 screws for a double oven or 2 screws for a
single oven). Failure
to do so could cause oven to move
or
tip during
use and result in personal injury.
Secure oven to cabinet with #8 screws provided. Do not
overtighten screws. Edge of front frame should be parallel
to cabinet. Disregard any excess screws that are left after
all screw holes in front frame have been used.
B. REPLACE OVEN RACKS IN OVEN CAVITY.
C. REINSTALL THE DOOR(S) (See Illus.)
DOOR REMOVE
FINGER TAB
1. Slide door hinge arms until firmly seated.
2. Lower door to full open position.
3. Push finger tabs to back. Depress the tabs and slide forward.
4. Close and reopen door slowly to make sure it has been replaced properly.
5. Repeat steps 1 through 4 for other door on double oven.