KitchenAid KSBN220 Side Burner Installation, Checking and adjusting the burners, Natural Gas

Side Burner

Installation

WARNING

Excessive Weight Hazard

Use two or more people to move and install side burner.

Failure to do so can result in back or other injury.

Natural Gas

This installation must conform with local codes and ordinances**. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1, or CAN/CGA-B149.1* Natural Gas and Propane installation code.

1. Place side burner into outdoor enclosure, but leave enough room in back to connect to gas supply.

WARNING

rear of	1/2" side burner
side burner
	gas pipe

flexible gas connector

•If local codes permit, use a flexible stainless steel tubing gas connector, design-certified and marked "outdoor" by AGA or CSA International, to connect the side burner to the rigid gas supply line. 5/8" diameter line is recommended. Using a wrench to tighten, connect the gas supply to the side burner. Use pipe joint compound on all non-flared male threads. Do not kink or damage the flexible connector when moving the side burner.

•Pipe-joint compounds suitable for use with L.P. gas must be used. Do not use Teflon® tape.

valve open

valve closed

7. Go to "Checking and adjusting the burners".

Checking and adjusting the burners

The burners are tested and factory-set for most efficient operation. However, variations in gas supply and other conditions may make minor adjustments to low flame setting necessary. Adjustments must be done by a qualified service technician.

Checking and adjusting the burner flames requires removing the grate.

valve stem

Explosion Hazard

Use a new AGA or CSA approved “outdoor” gas supply line.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person inclued:

licensed heating personnel, authorized gas company personnel, and

authorized service personnel.

Failure to do so can result in death, explosion, or fire.

2. Make gas connections.

A combination of pipe fittings must be used to connect the side burner to the existing gas line.

3. Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.

4.Test all connections by brushing on an approved non-corrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

cover

grate

5. Carefully lift off cover and grate and set aside. Remove packing from around burners. Reinstall grate.

6. Carefully move Side Burner completely into enclosure.

Low flame adjustment:

If flame goes out on the LO setting, the low flame setting must be adjusted.

Light the burner and turn control knob to its lowest setting and remove knob. Hold the valve stem with pliers and insert a thin flat blade screwdriver into the shaft. Watch the flame and slowly turn screwdriver counterclockwise. Adjust flame to the minimum stable flame. Replace control knob.

Reassemble grate.

Copies of the standards listed may be obtained from:

*CSA International

8501 East Pleasant Valley Rd. Cleveland, Ohio 44131-5575

**for local codes, contact your local building inspector

®T eflon is a registered trademark of E.I. Du Pont de Nemours and Company.

6