‘g%ndbg plug
power supply cord
15Move.1refrigerator close to final position. Remove cardboard or plywood from
under refrigerator. Plug electrical cord into the grounded outlet. Use the screw from the parts package to install the plug retainer. Move the refrigerator evenly and straight into the opening. Check that the water line will not be kinked. Check that slack in the electrical cord hangs freely behind refrigerator.
16. Check that the power switch at the too of the
cabinet is in the “OFF” position.
leveling rods clockwise using a 5/l 6” socket and ratchet until the cabinet weight is supported by the rear legs. Use
P-IIf side panels are not used, ’ go to Step 10. Read Side
panel requirements, page 5, before attaching side panels to refrigerator.
Connect the fitting to the refrigerator water valve. Do Not overtighten. (If necessary, the water valve can be removed from the underside of the cabinet to attach the fitting. You may have to remove the wiring channel to get to the valve. Remove the screw between the coils of the water valve. Remove the disconnected water valve and attach the fitting. Replace the water valve.) Slide compression nut and sleeve on tubing with fitting for water valve. Connect the union from the water supply line to the compression nut on the tubing from the water valve. Tighten with an adjustable wrench. Do Not
Turn the water supply valve to the open position. Turn the refrigerator switch to the “ON”position. Check all connections for leaks.
Page 9
Open both doors. Place a
18 level against the underside
. of the door trim at the top of the refrigerator. Adjust the front leveling legs until level and to the right height for the recessed area. Place the level on the crisper guide in the refrigerator section to check for levelness front to back. Turn the right, rear leveling rod until level and to the required height. Place the level on the freezer basket guide to level the left side of the cabinet.
/
Remove all tape and door bracina from
refrigerator door. Remoie the six screws that attach the handle to the door frame. Slide the refrigerator door panel into door frame. If the panel is less than l/4” thick, a filler panel will need to be installed between the door and decorative panel. If the decorative panel is more than l/4” thick, it will have to be routed to have a l/4” edge on all sides. See Custom panel and insert dimensions for exact sizes to cut custom panels.
