. the door handle insert, slide insert trim into
handle. See Custom panel and insert dimensions for exact sizes to cut custom inserts. Insert end caps into each end of door handle. Replace refrigerator door handle. (Some end caps are attached with screws.)
top grille is aligned with top trim on cabinet. Use ten screws to tighten top grille frame to refrigerator. Check that the power switch is in the “ON” position. Attach top grille decorative panel assembly to the keyhole bracket on the frame and pull down to secure. If the top grille decorative panel does not fit evenly within frame, the keyhole bracket can be moved side to side by adjusting the bracket screws, or the decorative panel bracket can be moved up or down by adjusting the decorator panel bracket nuts.
1171Open both doors. Use two screws to attach
n bottom arille to cabinet Loosen the four height adjustment screws. Adjust the bottom grille to fill the space from the floor to the bottom of the cabinet. Tighten adjustment screws.
112Repeat Steps 10 and 11 m for the freezer door.
113Remove two nuts from one end of the top panel
Put shelves and bins
set screws ,into the refrigerator and freezer compartments.
Remove protective film from door frame.
|
|
|
|
|
|
| Move the ice maker arm | |||||
|
|
|
|
|
| n | into | the down | position. | |||
|
|
|
|
|
|
|
| refrigerator and | ||||
|
|
|
|
| 119Set | |||||||
|
|
|
|
| freezer compartment controls to the | |||||||
|
|
|
|
| midpoint between | “COLD” and | ||||||
Personal | injury | Hazard | I | “COLDEST”. | Check that the | |||||||
compressor | is operating | properly. | ||||||||||
Reinstall | set screws after | |||||||||||
| Check that | all | five | interior | lights and | |||||||
door swing | is set. |
|
| one | exterior | light |
| above dispenser | ||||
Failure to | so could | result in |
| area | are working. |
|
| |||||
personal | injury. |
|
|
|
|
|
|
|
|
| ||
W frame. Remove end piece. Slide decorative panel into panel frame. Replace end piece using nuts.
Attach the two braces to
the refrigerator cabinet. Attach top grille frame to braces. Check that
Check that doors can open freely. If not, the door stops can be
adjusted. Loosen set screw in top and bottom hinges with Allen wrench. Determine the door swing desired. Hold door in that position and tighten the set screws. The doors have stops at 90°, 115O and 137O positions. If the door stops cannot be adjusted to clear countertops, the countertops may need to be mitered. (Consult your builder to adjust countertops.)
. connections at the bottom of the refrigerator
again for leaking. Any leaking can cause refrigerator and floor damage.
120Use a drinking glass to n press ice dispenser bar.
You should hear the
motor and auger operating. Press the glass against the water dispenser bar. Dispense and discard 2 to 3 quarts of water to remove air from system and rinse tank.
To get the most efficient use from your new
Page 10
