Door Panels for Dispenser Models
The two freezer panels combined should not weigh more than 30 lbs (13.5 kg). The refrigerator panel should not weigh more than 50 lbs (23 kg).
A |
|
|
|
|
| B |
| ||||||
|
|
|
|
|
|
|
23⁷⁄₁₆"
(59.5 cm)
70⁷⁄₁₆"
(179 cm)
34⁷⁄₁₆"
(87.4 cm)
Model | A | B |
|
|
|
36 | 14¹⁄₄" (36.2 cm) | 19¹⁄₄" (48.9 cm) |
42 | 16³⁄₄" (42.6 cm) | 22³⁄₄" (57.8 cm) |
48 | 19¹⁄₄" (48.9 cm) | 26¹⁄₄" (66.7 cm) |
|
|
|
|
|
| ¹⁄₄" |
|
|
|
|
|
| |
|
|
|
|
|
| (6.35 mm) max. |
¹⁄₂" |
|
|
| Top | ||
|
|
| ||||
(1.3 cm)
min.
Center face detail between 
offsets
³⁄₈"
(9.5 mm) |
|
|
|
|
|
|
min. |
|
|
| Bottom | ||
|
|
|
| |||
|
|
|
|
|
| ¹⁄₄" |
|
|
|
|
|
| |
|
|
|
|
|
| (6.35 mm) max. |
|
|
|
|
|
| |
Door Panels – Routing Requirements
If an extended handle kit is used, then routing the handle side of the panels is not required. See “Classic Series Factory Panels and Kits” for more information on ordering extended handles.
If the standard handle is used, rout the entire handle side of both panels 3¹⁄₄" (8.25 cm) to allow for finger clearance. Then rout the other sides 1" (2.54 cm).
Standard Handle – Top View
Top Grille Panel – Routing Requirements
Top and bottom edges of the top panel should be edge routed ¹⁄₂" (1.3 cm) and ³⁄₈" (9.5 mm), respectively. Both ends should be edge routed ⁷⁄₈" (2.2 cm) as shown.
Handle
3¹⁄₄"
(8.25 cm) min.
¹⁄₄" (6.35 mm) max.
2" (5 cm)
Hinge Side
Door | Door |
Panel | Panel |
1"
¹⁄₄"
¹⁄₄"
min.
(2.54 cm)
(6.35 mm) max.
⁷⁄₈"
(2.2 cm)
Top | Top |
Grille | Grille |
⁷⁄₈"
(2.2 cm)
(6.35 mm) max.
Door Panel - Side View
¹⁄₄"
(6.35 mm) max.
NOTE: When creating a panel with face detail, the offsets will be hidden and must be accounted for in order to center the detail in the top grille.
¹⁄₂" (1.3 cm) min.
Panel
12
