Install Side Panel
If the
IMPORTANT: KitchenAid is not responsible for the removal or addition of molding or decorative panels that would prevent the refrigerator from being serviced.
1.For the inside side trim piece, slide the front edge of the routed side panel into the trim piece.
2.Nail the rear edge of the panel to the support board.
A
B
A. Support board
B. Side trim piece
Install Base Grille
There are two pieces to the base grille to allow for a custom fit: the base grille itself and the skirt. The skirt can be added to the base grille in order to extend it all the way to the floor.
1.Open the refrigerator door and measure the distance from the bottom of the refrigerator cabinet to the floor.
B
|
|
|
|
|
|
|
|
|
|
|
|
A |
|
|
|
| C |
|
|
|
| ||
|
|
|
|
|
|
A.Floor
B.Refrigerator cabinet bottom
C.Distance to be measured
2.Measure this same distance from the top of the base grille to the closest “V” groove on the skirt. Use a knife to score down the “V” groove and break the skirt at the score line.
A
B
C
A. Grille and skirt assembly
B. Measured distance from above in Step 2
C. Score “V” groove
3.Slide the skirt onto the base grille.
4.Then attach the base grille to the cabinet with the two screws provided.
25
