KitchenAid KUDS30IV Mark line, Mark pilot holes, Attach body panel, Install custom panel, Back

3 Mark line

" (25.2 cm)

Back

Top edge

Measure 9²⁹⁄₃₂" (25.2 cm) from top edge and mark a line on the back of customer-supplied custom panel. Position the outer panel on the back of the customer-supplied custom panel as shown, so that the top holes in the outer panel are on the line, and both panels are centered side to side.

4 Mark pilot holes

Mark pilot

holes

6 Attach body panel

	Align top
Reinstall	edges
3 screws
each side	Customer-supplied
	panel

Attach the panel assembly to the door by reinstalling the three screws on each side; do not tighten completely. This reinstallation of the three screws will hold the panel assembly in place on the door frame.

7 Install custom panel

Customer-supplied

panel

Align top edges

Drill through

these holes

Mark all four hole locations; remove outer panel. Drill ³⁄₃₂" pilot holes ¹⁄₂" (13 mm) deep in customer-supplied custom panel. Place the outer panel on the back of the customer- supplied custom panel; align holes.

5 Attach handle

6"

(15.2 mm)

Hex Head

Screw

Attach outer panel to back of customer-supplied custom panel with the four #10-16 x ³⁄₈" hex head screws supplied in the literature package. Attach the handle. The handle should be centered on the front of the customer-supplied custom panel in the area shown.

IMPORTANT: Screw heads must be flush with back of customer-supplied custom panel.

16

Align the top edge of the customer-supplied custom panel with the top of the console.

Drill two ³⁄₃₂" pilot holes ¹⁄₂" (13 mm) deep, into the customer-supplied custom panel, through the holes in the top corners on the inner panel, as shown.

8 Install custom panel

Align top edges

Drill through

these holes

Customer-supplied

panel

1³⁄₈” Screw

Install the two #8-18 x 1³⁄₈" screws from

the literature package in the top corners of the inner panel. Tighten the six side screws reinstalled in Step 6.