INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Parts Supplied
Check that all parts are included.
A
B
Tools needed
■Pliers
■Phillips screwdriver
■
■³⁄₁₆" and ¼" nut drivers or hex sockets
■Measuring tape or ruler
■1½" hole saw bit
■10" adjustable wrench
■Utility knife
■Level
■Electric drill
■¹⁄₈" drill bit
■Security
C D E
F H G
Parts needed
B
A
C
D
E
A. 60" (152.4 cm) flexible water supply line
B. Zip tie
C. 2 appropriate sized UL listed wire connectors
D. Hardware (if installing custom front panels)
E. Overlay panel (if installing custom front panels)
I J
A. ³⁄₄" UL listed strain relief | G. Drain connector spring clamp |
B. 2 mounting brackets | H. 2 trim strips |
C. 1.25" hose clamp | I. 2 panel fasteners (on some |
D. 4 mounting bracket screws | models) |
E. 2 unit mounting screws | J. 10 TORX®† screws (on some |
F. Drain connector | models) |
|
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock.
Proper installation is your responsibility.
■Contact a qualified installer to ensure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances.
■Install the dishwasher as specified in these instructions.
■Have everything you need to properly install dishwasher.
■Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty.
■This dishwasher is manufactured for indoor use only.
■Install and level dishwasher on a floor that will hold the weight, and in an area suitable for its size and use.
†®TORX is a registered trademark of Textron Innovations Inc.
4