Installation Instructions, Water Supply Requirements

You must have:

■120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply.

■Copper wire only.

We recommend:

■A time-delay fuse or circuit breaker.

■A separate circuit.

If direct wiring dishwasher:

■Use flexible, armored or nonmetallic sheathed, copper wire with grounding wire that meets the wiring requirements for your home and local codes and ordinances.

■Use strain relief method provided with house wiring junction box or install a UL-listed/CSA-certified clamp connector to the house wiring junction box. If using conduit, use a UL-listed/CSA-certified conduit connector.

If connecting dishwasher with a power supply cord:

■Use Power Supply Cord Kit (Part Number 4317824) marked for use with dishwashers. Kit contents include:

■Voltex, Inc., UL listed 16 gauge 3 wire power supply cord with 3 prong grounded plug.

■Neer C-500 ⁷⁄₈" strain relief.

■3 wire connectors.

■Part Number 302797 grommet.

Follow the kit instructions for installing the power supply cord.

■Power supply cord must plug into a mating three prong, grounded outlet, located in the cabinet next to the dishwasher opening. Outlet must meet all local codes and ordinances.

IMPORTANT: If you plan to install a garbage disposer, an additional separate 120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply is required.

Water Supply Requirements

■A hot water line with 20-120 psi (138-862 kPa) water pressure.

■120°F (49°C) water temperature at dishwasher.

■Flexible stainless steel braided fill line (½" minimum plastic tubing is not recommended).

Drain Requirements

■Use the new drain hose supplied with your dishwasher. If this is not long enough, use a new drain hose with maximum length of 12 ft (3.7 m) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher.

■Connect drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20" (50.8 cm) minimum above the floor. It is recommended that the drain hose either be looped up and securely fastened to the underside of the counter, or be connected to an air gap.