KitchenAid KULSL85 installation instructions 21nit Wiring Diagrams, Check Operation

21nit Wiring Diagrams

This model operates at 115 volts except for the cutter grid circuit which operates at 8.5 volts at 1 amp.

The compressor runs at all times except when the Bin Thermostat becomes satisfied and opens the circuit. This de-energizes the system except for the transformer and cutter grid.

Under normal operating conditions, when the evaporator reaches the preset tempera- ture (+lO” to -3°F [-12” to -1 9”C], depending on thickness of ice) the evaporator thermo- stat opens, terminating operation of the fan motor and pump motor. The hot gas sole- noid and the water valve solenoid are energized at this time and remain so until the evaporator reaches 38” + 2°F (3” + 1%).

Electrical Shock Hazard

Disconnect power before servicing unit.

Failure to do so could result in electrical shock.

NOTE: Maximum fuse size: 15 amps.

Check Operation

a0 Start the unit by turning the service switch to “ON”and opening the line water valve.

tH NOTE: Left is “OFF’ - Middle is “ON”- Right is “CLEAN.” In ‘CLEAN” position, only the pump operates.

dCheck condenser fan to make sure it is revolving. Check for airflow. Do not insert hand into fan area.

dWater will not enter pump pan until freezing plate gets cold and machine goes into a harvest cycle.

d Check for even water flow over freez- ing plate. Unit must be level for proper operation.

dCheck for desired cube thickness and after 24 hours adjust if necessary. Maximum ice yield will be obtained with ice thickness at l/i’ (13 mm) to %” (16 mm).

d Replace grille.

11