Install Duct CoversComplete Installation
NOTE: Remove the film from the vertical duct cover supports and the duct covers.
1.Attach the vertical duct cover supports using 8 - 4 x 8 mm screws.
A
B
A
1.For
2.Install metal filters. See the “Range Hood Care” section.
3.Check the operation of the range hood blower and light. See the “Range Hood Use” section.
If range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
A.Screws
B.Vertical duct cover support
2.Slide the upper duct covers into place, and insert 3 tabs on each side of the duct covers into the mating slots of the vertical duct cover supports. Slide the duct covers up until the springs “click” and the tabs are locked in place.
A
B
A. Upper duct cover
B.Spring
3.Slide the lower duct covers over the upper duct covers.
4.Attach the lower duct covers together using a plastic bracket at each top and bottom corner of the lower duct covers
(4 places).
The range hood controls are located on the front side of the canopy.
A 
B 
G
C 
F
D 
E
A. Louver holes | D. Canopy |
[recirculating] installations only) | E. Grease filters |
B. Duct covers | F. Grease filter handles |
C. Lamp housings | G. Control panel |
C | A |
|
|
|
|
|
| Control Panel |
|
|
| ||
|
|
|
|
| ||
| B | A | B | C | D | E |
|
|
|
|
|
| |
C | A. Power decrease | |
B. Power increase | ||
| ||
A. Upper duct cover | C. Display | |
D. Light | ||
B. Lower duct cover | ||
E. Timer | ||
C. Plastic brackets | ||
|
9
