CUSTOM PANEL INSTALLATION INSTRUCTIONS
Custom Drawer Panel
If you plan to install a custom wood panel, you will need to create the panel yourself or consult a qualified cabinetmaker or carpenter. See dimension drawings for panel specifications.
IMPORTANT:
■The thickness of the custom panel must be ¹⁄₂" (1,3 cm) to ³⁄₄" (1.9 cm).
■Do not exceed the height dimension for the custom panel. A panel that exceeds the height dimension may damage the drawer dishwasher, cabinets or countertop.
■The width of the custom panel may vary according to the width of the cabinet opening.
Custom Panel Dimensions
Upper Drawer Panel
Preparing Custom Panel
1.Lay the custom panel face down on a clean, soft work surface.
2.Using a pencil, mark the centerpoints for the 2 panel fastener pilot holes and 6 pilot holes needed for the panel.
| 11¹⁄₄" | A | 11¹⁄₄" |
|
2¹⁄₂" | (28.5 cm) |
| (28.5 cm) | 1¹⁄₂" |
8¹⁄₈" |
| 8¹⁄₈" | ||
(6.3 cm) |
| (3.8 cm) | ||
| (20.7 cm) | (20.7 cm) | 8" | |
|
|
| B | (20.2 cm) |
|
|
|
| |
|
|
| C | 14¹⁄₈" |
|
|
|
| (36.6 cm) |
³⁄₄"
(1.9 cm)
23⁷⁄₁₆"
(59.5 cm)
16¹⁄₄"
(41.3 cm)
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (6)
3.Mark the centerpoints for the 2 panel fastener pilot holes and 4 pilot holes need for the lower panel.
| 11¹⁄₄" | A | 11¹⁄₄" |
|
|
|
| ||
| (28.5 cm) |
| (28.5 cm) | 1¹⁄₂" |
2¹⁄₂" | 8¹⁄₈" |
| 8¹⁄₈" | |
| (3.8 cm) | |||
(6.3 cm) | (20.7 cm) |
| (20.7 cm) |
|
Lower Drawer Panel
B | 10¹⁄₂" |
(26.7 cm) |
³⁄₄"
(1.9 cm)
23⁷⁄₁₆"
(59.5 cm)
12³⁄₄"
(32.4 cm)
C |
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (4)
4.Using a ¹⁄₈" drill, drill each hole ³⁄₈" (1 cm) deep.
Hardware Installation
Center the hardware (left to right) onto the custom panel. When installing the hardware, be sure that the mounting screws are flush with the back of the custom panel.
³⁄₈" (1 cm)
IMPORTANT: To avoid drilling through to the front of the custom panel, do not drill deeper than ³⁄₈" (1 cm).
17
