KitchenAid W10526089A Natural Gas Conversion, To Convert Gas Pressure Regulator

Models: W10526089A

1 44
Download 44 pages 19.96 Kb
Page 20
Image 20

Natural Gas Conversion

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

To Convert Gas Pressure Regulator

1.Turn manual shutoff valve to the “closed” position.

F

Side view before

A

B F

DE

N

CSide view after

A. Plastic cover

B. Gas pressure regulator cap with hollow end facing out C. Gas pressure regulator cap with solid end facing out

D.Washer

E. Gas pressure regulator cap

F. Gas regulator shutoff valve (shown in the “open” position)

6.Turn the gas pressure regulator cap over and reinstall on regulator so that the solid end faces out and letter “N” is visible.

7.Replace plastic cover over gas pressure regulator cap.

B

A

C

A. To range

B. Manual shutoff valve “closed” position

C. Gas supply line

2.Unplug range or disconnect power.

3.Remove warming drawer or storage drawer. See the “Remove Warming or Storage Drawer” section for instructions. Locate gas pressure regulator at rear of storage or warming drawer compartment.

NOTE: On models with a warming drawer, an access cover must be removed from the gas pressure regulator.

A

To Convert Standard Surface Burners

1.Remove burner cap.

2.Using a T20® TORX® screwdriver, remove the burner base.

3.Apply masking tape to the end of a 7 mm nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside.

C

A

D

B

A. Gas pressure regulator

IMPORTANT: Do not remove the gas pressure regulator.

Gas pressure regulator

4.Remove plastic cover from gas pressure regulator cap.

5.Turn gas pressure regulator cap (marked “LP” on front of gas pressure regulator) counterclockwise with a wrench to remove.

NOTE: Do not remove the spring beneath the cap.

A. Igniter electrode B. Gas tube opening C. Burner cap

D. Burner base

20

Page 20
Image 20
KitchenAid W10526089A installation instructions Natural Gas Conversion, To Convert Gas Pressure Regulator