love washerldryer to its ermanent location.

Check levelness of n washer/dryer by

Ilacing a carpenter’s level on top of dasher, first side to side then front I back. If it is not level, screw the ‘ant legs up or down to adjust. Tilt rasher forward raising back legs 1” IHof floor to adjust rear self- :veling legs. Gently lower washer

3 floor. Make final check with level.

22 n

‘ut “hook” end of drain hose in tub jr standpipe. Secure drain hose by vrapping the plastic strap around he hose as shown in Figures A-C. f drain hose cannot be strapped in ,lace, it must be cut exactly to length io the “hook” end is held tightly over he edge of the tub or standpipe as ihown m Figure D.

:HECK THAT HOSE IS NOT MISTED OR KINKED AND IS jECURELY IN PLACE.

24.

To exhaust the dryer straight from lack of the washer/dryer unit, jetermine if any additional exhaust duct is needed (see Exhaust qequirements. Panel 6). To exhaust

.he dryer to either side or Inside :heck If additional exhaust duct is Teeded and see Alternate Exhaust Wethods. Panel F Connect exhausl jucl to exhaust hood.

Use duct tape to seal all joints.

26.

CHECK ELECTRICAL REQUIREMENTS. BE SURE YOU HAVE CORRECT ELECTRICAL SUPPLY AND RECOMMENDED GROUNDING METHOD. Check the installation inslructlons to see that you have completed each step. Complete any missed steps before you continue.

Check that all parts are now installed. See parts list, Panel A. If there is an extra part, go back through steps to see which step

DhilliDs screwdriver

Check that you have all of your tools

30.

Turn on waler faucets and check for leaks. Tighten couplmgs if there is leaking.

31.

Plug electrical cord into grounded outlet.

32.

If access panel was removed to install ductwork, replace access panel. Be sure to tighten both screws.

33 1

Take a few minules and read the Use and Care Guide to fully understand your new wastierldryer. Now start the washer and allow

it to complete the regular cycle.

Remove the tape across the dryer lint screen. Check to be

sure lint screen is in its proper position. Wipe out drum. Start dryer and allow it to complete a cycle to make sure the dryer is working properly

35.

Finally, save all literature and keep with the washer/dryer. Save all shlpping materials for reshipping.

You have

successfully Installed your KItchenAid washer/dryer.

To gel the most efliclent use from your new washer/dryer read your KItchenAId Use and Care Guide.

?xhausf ductwork can not be

 

 

 

 

 

 

:onnected from the side of the

 

 

 

 

 

 

vasher/dryer, the exhaust duct can

Check that you removed all the

)e reached from the front, through

shipping pieces including the three

he access panel. Remove the

shipping

straps with

keys.

 

access panel by unscrewing 2

 

)hllllps heads screws located at

If you

do

not

remove

the

shipping

he top of the panel. Set panel and

straps,

your

washer/dryer

may -

icrews aside

“walk” awav

from its tocatlon.

NEL E

Congratulations!

Keep lnete~ation instructions nearb)

 

where you can refer to them.

 

They’ll make re-InstallIng

 

your KItchenAId washer/dryer

 

In another home es easy

\

es the first Instattatlon. /

Page 6
Image 6
KitchenAid Washer/Dryer installation instructions Congratulations, Nel E