Chapter 3: Getting Started

Observing the IMPORTANT SAFETY INSTRUCTIONS at the front of the manual and the guidelines in "Precautions" on page vii, carry out the following to get your DN540 unit fully operational.

Unpacking

Carefully unpack your DN540 equipment package.

Then, inspect the DN540 unit carefully for any signs of damage that may have occurred during transit and notify the courier immediately if you discover any.

Check the contents of your DN540 equipment package. If there are any parts missing, incorrect or faulty, please contact your local distributor or Klark Teknik at the address at the front of this manual. The following is a list of the main items contained in the DN540 package.

Quantity

Description

Part number

 

 

 

1

DN540 unit

Not applicable

1

DN540 Operator Manual (this document)

DOC02-DN540

1

Warranty card

DOC04-WARRANTY

1

Mains lead

PWR21-MAINSLEAD

 

 

 

Please retain the original packing in case you should need to return the equipment to the manufacturer or supplier, or transport or ship the unit later.

Checking the mains fuse

Before installing the equipment you need to make sure that the mains fuse fitted is of the correct type and rating for your unit. To do this refer to “Replacing the mains fuse” on page 39.

Installation

This unit is designed for mounting in any 19” EIA standard rack. Four rack-mount holes in the front panel are provided for rack mounting and are designed to fully support the weight of the unit in the rack.

Note: Avoid over-tightening the rack-mount screws, as this could damage the front panel.

The position of the unit will depend upon how it is to be used. However, when positioning the unit, avoid placing it where the control knobs may be damaged by being accidentally knocked or snapped off. Also, try to avoid placing the unit directly near or on any power distribution units or power amplifiers.

DN540

 

Operator Manual

9

Page 21
Image 21
Klark Teknik DN540 specifications Getting Started, Unpacking, Checking the mains fuse