Chapter 3: Getting Started

Connecting to unbalanced equipment

Ideally, you will be making the best use of the DN540’s low-noise high-headroom balanced inputs by connecting to similarly balanced equipment. However, if you do have to connect to unbalanced devices, the following wiring is recommended for best results (see Figure 3):

Connect the +ve (pin 2) of the balanced connection to the +ve terminal on the unbalanced connector.

Connect the -ve (pin 3) of the balanced connection to the common (ground) terminal on the unbalanced connector.

Connect the ground (pin 1) of the balanced connection to the common (ground) terminal on the unbalanced connector.

The following diagram shows the wiring details for the insert send/return 1/4” TRS connector/XLRs.

To external sidechain socket

Console

Sleeve

Ring

Tip

Single channel

 

 

 

DN540 (rear panel)

 

 

 

 

 

 

 

connections on

 

 

 

 

 

 

 

rear of unit

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Female XLR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Male XLR

 

 

1

2

Tip

3

 

Female XLR

Ring

2

 

Sleeve

1

 

3

Male XLR

 

 

Powering the unit

To power up the unit, switch on the power at the mains power outlet. The blue power LED on the front of the unit (far right) will illuminate to show that power is on.

Your unit is now ready to operate.

To switch off the DN540, switch off the mains at the mains power outlet. Then, to electrically isolate the unit, remove the mains cable from the mains IEC socket on the rear panel.

 

DN540

12

Operator Manual

Page 24
Image 24
Klark Teknik DN540 specifications Powering the unit, Connecting to unbalanced equipment