HDP2100 Users Manual
LED Error Messages
| ERROR CODE MESSAGES |
| POWER LED | READY LED |
|
| BLINK | BLINK | |
|
|
| ||
|
|
|
|
|
| Lamp Ready | ON | ON | |
|
|
|
| |
| Start | ON | OFF | |
|
|
|
| |
| Cooling | ON | FLASHING | |
|
|
|
| |
| Over temperature | OFF | OFF | |
|
|
|
| |
| Thermal Break Sensor error | 4 | 4 | |
|
|
|
| |
| Lamp End of lamp life detected | 5 | 3 | |
|
|
|
| |
| Burner Fan error | 6 | 1 | |
|
|
|
| |
| Lamp Fan error | 6 | 2 | |
|
|
|
| |
| Power Fan error | 6 | 3 | |
|
|
|
| |
| DMD Fan error | 6 | 4 | |
|
|
|
| |
| Case Open | 7 | OFF | |
|
|
|
| |
| DMD error | 8 | OFF | |
|
|
|
| |
| Color wheel error | 9 | OFF | |
|
|
|
|
|
TEMP LED
BLINK
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re- starting the projector. If the POWER or LAMP LEDs are still blinking or the TEMP LED is lit, contact your service center.
Image Problems
Problem: No image appears on the screen
1.Verify the settings on your notebook or desktop PC.
2.Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1.Adjust the Focus on the projector.
2.Press the Auto button on the remote control or projector.
3.Ensure the
4.Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1.Position the projector so it is as perpendicular to the screen as possible.
2.Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked
1.Set the Frequency and Tracking settings on the Computer menu of the OSD to the de- fault settings.
2.To ensure the problem is not caused by a connected PC’s video card, connect to another computer.
– 35 –
