HDP2100 Users Manual
Replacing the Lamp
Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 30 for clear and safe instructions for this procedure. Before replacing the lamp:
Unplug the power cord.
Allow the lamp to cool for about one hour.
Cleaning the Projector
Unplug the power cord before cleaning. See Cleaning the Projector on page 32.
Allow the lamp to cool for about one hour.
Regulatory Warnings
Before installing and using the projector, read the regulatory notices in the Regulatory Compliance section on page 43.
Important Recycle Instructions:
Lamp(s) inside this product contain mercury. This product may contain other electronic waste that can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal Laws. For more information, contact the Electronic Industries Alliance at WWW.EIAE.ORG. For lamp
specific disposal information check WWW.LAMPRECYCLE.ORG.
Symbol Explanations
DISPOSAL: Do not use household or municipal waste collection services for disposal of electrical and electronic equipment. EU countries require the use of separate recycling collection services.
Main Features
•Lightweight unit, easy to pack away and transport.
•Compatible with all major video standards including NTSC, PAL, and SECAM.
•A high brightness rating allows for presentations in daylight or in lit rooms.
•Supports resolutions up to SXGA+ at 16.7 million colors to deliver crisp, clear images.
•Flexible setup allows for front, rear projections.
•
•Input source automatically detected.
About this manual
This manual is intended for end users and describes how to install and operate the DLP projector. Wher- ever possible, relevant
— iv —