21
When Autosource is not checked, the projector defaults to Component initially, then defaults to whatever the last active source was when the projector was powered down. To display another source, you must manually select one by pressing the Source button on the remote or keypad. This cycles through all the sources that are selected in the Source Enable menu.
The Source 1, 2, and 3 menus in the Sources menu allow | Sources | Source Enable |
you to assign a source to the Source 1, 2, and 3 buttons |
|
|
on the remote. The Source 4 menu selection would |
|
|
apply to the Custom key if that option is chosen in the |
|
|
Custom key menu, see page 22. |
|
|
To use the SCART RGB source, you must first select it in the Source Enable menu (the projector cannot automatically detect this source). Enabling SCART will disable Component and Composite sources.
System>OSD Offset: System>OSD Offset: allows you to adjust the position of the OSD. By default, the menus are postponed in the upper left hand corner of the displayed image and the messages are postponed in the lower left hand corner. Adjust the offset to move these items more to the right and middle of the display.
Rear: reverses the image so you can project from behind a translucent screen.
Ceiling: turns the image upside down for
Auto Ceiling: uses an internal sensor to automatically turn on ceiling mount mode if the projector is inverted.
High Power: maximizes the light output of the lamp.
Auto Power: when AutoPower is checked, the projector automatically goes into the startup state after the projector receives power. This allows control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as “Searching”) in the
Translucent OSD: makes the menus translucent. This prevents the image from being completely covered by the menus while you are making image adjustments.
Sleep Timer: automatically turns off the projector after 4 hours.
Power Save: automatically turns the lamp off after no signals are detected for 20 minutes. After 10 additional minutes with no signal, the projector powers down. If an active signal is received before the projector powers down, the image is displayed.
Startup Logo: allows you to display a blank screen instead of the default screen at startup.
.
Blank Screen: determines what color is displayed when you select Blank Screen in the Startup Logo menu and when no source is displayed.
