Knoll Systems HT200 user manual Before connecting

Connecting Component Video Equipment withYCbCr output jacks to the RGB IN connector

You can also connect the video component to the RGB IN connector, if the video component has the component video (YCbCr) signal jacks. This connection may provide a better picture quality than the connections on page 9.

•You can switch the input source to VIDEO, S-VIDEO, or RGB.

•The AUDIO IN jack is for equipment connected to the RGB IN connector.

Before connecting

•Turn off the components that are to be connected.

•The projector and computer will be turned on in "Using the Projector" on page 13.

Do not turn on either the computer or unit until you read this section.

•Please also refer to the manual of the video component to be connected.

If you are connecting a 5 wire BNC cable to a 15 pin D-sub, you may need three 21-131-0 BNC to RCA adaptors.

Connect the 15 pin D-sub into the projector. Connect the red BNC to the Cr output. Connect the green BNC to the Y output. Connect the blue BNC to the Cb output.

The remaining black and grey BNC connectors are not used in this case.

10