Kobe Range Hoods CH9630SQB, CH9648SQB, CH9642SQB, CH9636SQB Duct Co ver Installation, Accessories

Duct Co ver Installation

6.Mark the position of the inner duct cover-

mounting bracket {J} (provided). Use reference E from TABLE 2 and Measurements and Diagrams on page 20-21. Attach and secure inner duct cover-mounting bracket {J} with two screws (not provided) to the wall. Refer to Figure 15. NOTE: Inner duct cover will be attached to the mounting bracket.

7.Use 7” round steel pipe (follow building codes in your area) to connect the round exhaust on the hood to the ductwork above. Use duct tape to make all joints secure and air tight.

8.Slide the inner duct cover up 2 inches before sliding the entire duct cover onto the hood. Refer to Figure 16.

9.Adjust the height of the inner duct cover to the inner duct cover-mounting bracket {J}. Secure the inner duct cover with two (1/8” x 3/8”) screws (provided).

10.Fasten outer duct cover to outer duct cover- mounting bracket {K} with two (1/8” x 3/8”) screws (provided) as shown in Figure 17.

Figure 15

Figure 16

Accessories

11.Drop oil tunnel into recess support near rear of hood. Refer to Figure 18.

12.Install baffle filters and stainless spacer(s). Refer to Measurements and Diagrams on page 22 for baffle filter and stainless spacer placement. Angle baffle filter toward back of hood ￿. Push baffle filter up until almost level ￿. Slide forward into recess behind the front of hood ￿. Lower baffle filter ￿. Slide back until it fits into resting position ￿. Refer to Figure 19.

13.Repeat step 12 to install all baffle filters and stainless spacer(s).

Figure 17

Figure 18

11