the back edge of the custom wood frame. Use a pen to Figure 4 trace the outline of the
and proceed to Hood Preparation Before Installation.
9.Install the rear section of the liner with 6 screws (not included).
10.Install the front section of the liner with 3 screws (not included)
11.Proceed to Hood Installation on Page 7.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY QUALIFIED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
12.Temporarily wire the hood to test for proper operation before installing. If the insert does not operate, check the circuit breaker or house fuse. If the insert is still not working, disconnect the power supply and check the continuity of all wiring connections.
13.Connect electrical wires.
14.Connect three wires (black, white and green) to house wires and cap with wire connectors. Connect wires according to their colors (i.e. black to black, white to white, and green to green). See Figure 3.
15.Store wires in the wiring box.
Note: Connect all electrical wires before installing insert. DO NOT turn on the power until installation is complete.
Figure 5
Figure 6
Duct Work Installation
16.Use 7” steel pipe (follow building codes in your area) to connect the ducting on the hood to the ductwork above. Use duct tape to seal and secure joints as shown in Figure 4.
17.Please refer to local codes for the usage of the damper (not included).
Figure 7
Hood Preparation Before Installation
CAUTION: If moving the cooking range is necessary to install the hood, turn off the power in an electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
18.Determine and mark the centerlines on the base of the wood frame where the insert will be installed.
19.Determine and make all necessary cuts in the wall or ceiling for the ductwork. Note: Install the ductwork
6
