Kobe Range Hoods RA9236S manual Peel protective film off the duct cover and the hood if any

-Temporarily wire the hood to test for proper operation before installing.

-Peel protective film off the duct cover and the hood (if any).

-Loosen hood-mounting brackets at the back of the hood, adjust brackets and screws as shown in Figure 3.

-If necessary to remove the rubber stand on the back of the hood, unscrew an Refer to Figure 4.

Figure 1

Attached

Rubber Stand

Figure 3

Hood Installation

CAUTION: If required to move the cooking range to install the hood, turn OFF the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

1.Using references on Table 1 and measurements on page 13, mark the leveling poi hood-mounting bracket on the wall.

2.Secure two mounting screws (not provided) on the wall leaving 1/8￿ away from t Refer to Figure 5.

3.Align hood-mounting bracket to the mounting screws on the wall and hook hood i place.

4.Secure and tighten the mounting screws. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.

5