Kobe Range Hoods RA9236S, RA-092 SERIES manual Attach Together

9.Using referenceEfrom Table 1 and measurements on 13,pagemark the leveling point for duct cover-mounting bracket.

10.Secure the duct cover-mounting bracket to the wall with two screws (not provi to Figure 7. Make sure all screws are tightened. NOTE: Inner duct cover will duct cover-mounting bracket.

11.Slide up inner duct cover up 2 inches before sliding entire duct cover onto t Refer to Figure 8.

Figure 7

12.Adjust the height of the inner duct cover to the duct cover-mounting bracket. inner duct cover with two (4x8 mm) screws (provided) as shown in Figure 9.

Attach Together

Figure 9

13.Fasten outer duct cover to plastic plate on the hood with four (4x8 mm) screw

Install Accessories

14.Place the oil container (round) into keyhole under each safety screen. Turn until firmly in place. Refer to Figure 10.

15.Slide oil container (oval) into plastic slot behind each safety screen as sho 11.

7