Toshiba dk14 manual Isdn, Flowchart

ISDN System Programs

*42 Clock Source

System power must cycle OFF and ON to effect changes.

*41 T1 Assignments

*42 Clock Source

Program *63 Set ISDN dialing timers.

network interface.

(SPID) number.

D-channel and

Service Profile ID

Assign the PRI

Initialize BRI

Program *43

Program *44

Program *60 Assign BRI circuits for CO line (TE) or Station (NT) operation.

PRI

BRI

T1

Program 03 Assign BRI or PRI card slots.

ISDN

System Programs Overview

2934

Flowchart 7-1

➤To record and enter the data for ISDN system programs

1.Run Program 03-Assign the RPTU (PRI) PCB slot position as type 79. (See “Program 03 for DK424 – Flexible PCB Cabinet Slot Assignments” on Page 3-6 .) Assign the RBSU without the RBSS piggy-back board as type 77 and the RBSU with the RBSS piggy-back as type 78.

2.For BRI, run Program *60 to assign each circuit for CO line (TE) or Station (NT) operation.

3.Turn system power supply OFF (five seconds) and ON to activate Program 03 and *60 program data.

Note These are the only programs relating to RPTU operation that require system power to be cycled OFF and ON.

4.For PRI, run Program *43 to assign which channel on the PRI link is used for the D-channel. The second assignment specifies the card slot of additional PRI links that are dependent on the master D-channel PRI. The third assignment sets the ID code for the PRI link. For BRI, skip to Step 5.

7-2 Strata DK Programming 5/99