Toshiba dk14 How to Program a Strata DK System, Programming Section Layout, 1-10, see Figure

Overview

How to Program a Strata DK System

How to Program a Strata DK System

Fill out the record sheets that are provided, then enter this data using a 20-button LCD digital (DKT) or electronic (EKT) telephone. Strata DK enables you to enter data from an on-site or off- site PC with Toshiba DKAdmin software. Toshiba highly recommends this easier method of programming.

DK14/DK40i: the programming telephone must be any 20-button LCD DKT (or EKT, DK40i only). The DKT must be connected to a Base KSU, PDKU, RDSU, QCDU, or KCDU digital port. An EKT must be connected to a PEKU port.

DK424: the programming telephone must be a 20-button LCD DKT or EKT connected to circuit 6 of a PDKU or PEKU installed in cabinet slot 11 and/or slot 12.

Note Telephones connected to an RDSU or PESU cannot be used to program DK424.

Programming Section Layout

Each programming section within a chapter begins with the program’s number and title, followed by processor and program type, initialized default, program sequence, then record sheets. A program overview and additional program information are given after the record sheets

(see Figure 1-1).

Note Some common program sections also include examples for your convenience.

		Program 30 Station Class of Service		System Programs
Program Overview		Program 30 Overview
Brief description of program		Program 30 enables or disables features for individual telephones at the station level. The following text
		describes Program 30 LEDs.
function(s).		Privacy Override, LED 19
		With Privacy Override enabled (LED 19 ON), a station can override calls and listen to a CO line
		conversation by pressing a common CO line button (not a [DN] button). You can set a warning tone for
		Privacy Override (see Program 10-2).
	Program 30 Station Class of Service		System Programs
Number/Title	Program 30
	Station Class of Service
	Processor Type: DK14/DK40/DK424
	Program Type: System
	Initialized Default: LEDs 01, 05 and 07 for all ports
Program Sequence

Additional Program

Information

Additional details on the program features that were given on the system record sheet.

Processor Type

Gives the type of processor that is compatible with the given program. Be sure to read this information

Keystrokes for entering data from system record sheets follow a pattern, consisting of a five-step process described and illustrated in “Program Sequence” on Page 1-13.

Record Sheet

Provides a list of available features. The sheet is used to record the assignment of features or the operation of each program. Each sheet provides space to record data. This data will be referred to when programming the system.

SELECT = Station Logical Port Number(s)	Buttons/LEDs
	Light LEDs for the port specified in the
	last step. All LEDs marked with an “X”
	in the table below should be lit.

Feature LED Port

20

19

18

17

16

15

14

13

12

11

10

09

08

07

06

05

2174

before attempting to use a program with your system application.

Program Type

Type of function the program performs. Can be: Initialization, Test System, Station, Toll Restriction or Least Cost Routing.

Initialized Default

Default configuration set by Program 91-9 “System Initialization” when the system is first installed or re-initialized.

Figure 1-1 System Record Sheet Sample

1-10 Strata DK Programming 5/99