Toshiba dk14 Program 50- - LCR Dial 0 Zero Time-out, +ROG6SNU+ROG6SNU+ROG, Program 50-6Overview

Least Cost Routing

￿￿￿￿￿￿￿￿￿￿￿￿￿￿6SNU ￿￿+ROG￿6SNU￿		+ROG￿6SNU￿￿+ROG￿6SNU￿￿+ROG
		Program 50-6 – LCR Dial 0 (Zero) Time-out
Program 50- – LCR Dial 0 (Zero) Time-out
Processor Type:	DK14, DK40i, All RCTUs
Program Type:	Least Cost Routing

Initialized Default: Assigns an LCR Dial Zero Time-out value of 06

SELECT = 6

DATA = Time-out Value

Enter a time-out value from 04~10 seconds long.

Program 50-6 Overview

Enter the maximum number of seconds LCR waits for a user to dial additional digits after a 0, before it routes the call to an operator for assistance. LCR waits this number of seconds to receive additional digits that indicate charge calls, collect calls or other 0+ calls.

♦The allowed range is 04~10 seconds. Always enter two digits.

♦Dial 0 calls will be restricted when using 0 + Credit Card calling (Program 43) if a telephone number is not dialed after dialing 0 or if Dial 0 is restricted in Program 46 (10~80).

Overview for Programs 51~54

These programs provide the system with directions for routing all possible calls, made by all possible users at all possible times of day. Tables for Programs 51~54 appear on LCR Route Plan Numbers 1~16. The following instructions show how to fill in individual tables within the plans. Each of the following program tables must be completed for all plans.

Programs 51~54 defines LCR route plans (quantities given below):

Processor	LCR Route
	Plans
DK14	8
DK40i	8
RCTUA	8

Processor	LCR Route
	Plans
RCTUBA/BB	8
RCTUC/D	16
RCTUE/F	16

These separate plans provide the customer flexibility enough to route different area codes and exception office codes over different line groups.

Least Cost Routing

Strata DK Programming 5/99 5-9