Strata DK

Strata DK

General End User Information

The Strata DK Digital Business Telephone System is registered in accordance with the provisions of Part 68 of the Federal Communications Commission’s Rules and Regulations.

FCC Requirements

Means of Connection: The Federal Communications Commission (FCC) has established rules which permit the Strata DK system to be connected directly to the telephone network. Connection points are provided by the telephone company— connections for this type of customer-provided equipment will not be provided on coin lines. Connections to party lines are subject to state tariffs.

Incidence of Harm: If the system is malfunctioning, it may also be disrupting the telephone network. The system should be disconnected until the problem can be determined and repaired. If this is not done, the telephone company may temporarily disconnect service. If possible, they will notify you in advance, but, if advance notice is not practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Service or Repair: For service or repair, contact your local Toshiba telecommunications distributor. To obtain the nearest Toshiba telecommunications distributor in your area, call Toshiba America Information Systems, Inc., Telecommunication Systems Division in Irvine, CA (949) 583-3700.

Telephone Network Compatibility: The telephone company may make changes in its facilities, equipment, operations, and procedures. If such changes affect the compatibility or use of the Strata DK system, the telephone company will notify you in advance to give you an opportunity to maintain uninterrupted service.

Notification of Telephone Company: Before connecting a Strata DK system to the telephone network, the telephone company may request the following:

1.Your telephone number.

2.FCC registration number:

Strata DK may be configured as a Key or Hybrid telephone system. The appropriate configuration for your system is dependent upon your operation of the system.

If the operation of your system is only manual selection of outgoing lines, it may be registered as a Key telephone system.

If your operation requires automatic selection of outgoing lines, such as dial access, Least Cost Routing, Pooled Line Buttons, etc., the system must be registered as a Hybrid telephone system. In addition to the above, certain features (tie Lines, Off-premises Stations, etc.) may also require Hybrid telephone system registration in some areas.

If you are unsure of your type of operation and/or the appropriate FCC registration number, contact your local Toshiba telecommunications distributor for assistance.

DK14 and DK40i

Key system: CJ6MLA-74479-KF-E

Hybrid: CJ6MLA-74478-MF-E

DK424

Hybrid: CJ69XA-10243-MF-E

Key system: CJ69XA-10242-KF-E

PBX: CJCHN-22757-PF-E

3.Ringer equivalence number: 0.3B. The ringer equivalence number (REN) is useful to determine the quantity of devices which you may connect to your telephone line and still have all of those devices ring when your number is called. In most areas, but not all, the sum of the RENs of all devices connected to one line should not exceed five (5.0B). To be certain of the number of devices you may connect to your line, as determined by the REN, you should contact your local telephone company to ascertain the maximum REN for your calling area.

4.Network connection information USOC jack required: RJ1CX, RJ2EX, RJ2GX, RJ48C, RJ48X, RJ11, RJ14C, RJ21X (see Network Requirements in this document). Items 2, 3 and 4 are also indicated on the equipment label.

Radio Frequency Interference

Warning: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the manufacturer’s instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case, the user, at his/her own expense, will be required to take whatever measures may be required to correct the interference.

This system is listed with Underwriters Laboratory.

 

 

 

 

UL Requirement: If wiring from any telephone exits the building or is

U

 

subject to lightning or other electrical surges, then secondary protection

L

is required. Secondary protection is also required on DID, OPS, and tie

®

lines. (Additional information is provided in this manual.)

 

 

 

 

Important Notice — Music-On-Hold

In accordance with U.S. Copyright Law, a license may be required from

the American Society of Composers, Authors and Publishers, or other similar organization, if radio or TV broadcasts are transmitted through the music-on-hold feature of this telecommunication system. Toshiba America Information Systems, Inc., hereby disclaims any liability arising out of the failure to obtain such a license.

CP01, Issue 8, Part I Section 14.1

Notice: The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The Department does not guarantee the Equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

CAUTION! Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

CP01, Issue 8, Part I Section 14.2

Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The terminal on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the Devices does not exceed 5.

Publication Information

Toshiba America Information Systems, Inc., Telecommunication Systems Division, reserves the right, without prior notice, to revise this information publication for any reason, including, but not limited to, utilization of new advances in the state of technical arts or to simply change the design of this document.

Further, Toshiba America Information Systems, Inc., Telecommunication Systems Division, also reserves the right, without prior notice, to make such changes in equipment design or components as engineering or manufacturing methods may warrant.

DKA-MA-PRGRM-VE 4025060

Version E, May 1999

Version D.3, December 1998 (Format change)

Version D.2, October 1998 (Update TBDK-0021)

Version D.1, September 1998 (Update TBDK-0019)

Version D, June 1998 (Update TBDK-0009)

Version C, October 1997

Version B, April 1997

Version A.1, February 1997 (Update TB16-0003)

Version A, December 1996

© Copyright 1999

Toshiba America Information Systems, Inc. Telecommunication Systems Division

All rights reserved. No part of this manual, covered by the copyrights hereon, may be reproduced in any form or by any means—graphic, electronic, or mechanical, including recording, taping, photocopying, or information retrieval systems—without express written permission of the publisher of this material.

Strata is a registered trademark of Toshiba Corporation. Stratagy is a registered trademark of Toshiba America Information Systems, Inc. Strata AirLink, Call Center Viewer are trademarks of Toshiba America Information Systems, Inc.

Trademarks, registered trademarks, and service marks are the property of their respective owners.

Page 2
Image 2
Toshiba dk14 Strata DK General End User Information, FCC Requirements, Radio Frequency Interference, Copyright, DK424

dk14 specifications

The Toshiba DK14 and DK40I are advanced digital video recorders (DVRs) that have redefined the standard for high-quality video surveillance systems. Designed primarily for security applications, both models boast a suite of impressive features, making them ideal choices for various environments, including commercial, retail, and educational settings.

The Toshiba DK14 stands out with its exceptional recording capabilities. It supports high-definition video capture, ensuring that every detail is captured with crystal clarity. The device can handle multiple camera inputs, allowing users to connect several surveillance cameras simultaneously, depending on the configuration. With its robust storage capacity, the DK14 can accommodate extended recording times, making it suitable for long-term surveillance needs.

One of the key characteristics of the DK14 is its user-friendly interface, which simplifies operation for both novice and experienced users. The system comes equipped with advanced motion detection technology, enabling it to trigger recording only when movement is detected, significantly optimizing storage use. Moreover, it features remote access capabilities, allowing users to monitor live feeds and review recorded footage from virtually anywhere via smartphone or computer.

In comparison, the Toshiba DK40I offers enhanced features targeted towards users requiring higher processing power and larger storage capabilities. This model is equipped with advanced compression technologies such as H.264, which reduces file sizes without compromising video quality. It can support higher-resolution cameras, further enhancing the clarity and detail of recorded footage.

The DK40I also prides itself on its scalability, accommodating numerous input channels, making it suitable for expansive surveillance setups. Another significant feature is its sophisticated alarm management system, which can integrate with various security sensors and alarms, providing users seamless control over their security environment. The device also supports various video outputs, including HDMI and VGA, ensuring compatibility with a wide range of display systems.

Both models utilize Toshiba's commitment to reliability and performance, incorporating high-grade components designed to withstand the rigors of continuous operation. They are engineered for ease of maintenance, with options for firmware updates and technical support, ensuring that users benefit from the latest advancements in surveillance technology.

Overall, Toshiba’s DK14 and DK40I represent cutting-edge solutions in the realm of digital video recording, offering exceptional performance, versatility, and user-friendly features to cater to diverse surveillance needs.