Kobe Range Hoods RA3836S, RA3830S installation instructions

4.Using references on Table 2 and measurements on page 15, decide the leveling p the hood. Position two mounting screws (not provided) on the wall, leaving 1/ from the wall as shown in Figure 11.

5.Align hood-mounting bracket to the two screws on the wall and hook hood into p Tighten screws to secure hood to the wall. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.

Hood-
		Mounting
Mounting
		Screws
Bracket
	Figure 10

Duct Cover Installation

6.Mark the position of the duct cover-mounting bracket. EUsefromreferenceTable 2 and measurements on page 15. Attach and secure duct cover-mounting bracket with t screws (not provided). Refer to Figure 12. NOTE: Inner duct cover will cover cover-mounting bracket.

7.Connect electrical wires. Refer to ￿Wiring to Power Supply.￿ If necessary to electrical wire connections, push wires back into the wiring box. Access the connections underneath the hood by removing the bottom casing from the six scr Before reattaching the bottom casing, make sure wires do not slip between moto impellers, or any moving parts to prevent any damage.

8.Use aluminum or steel pipe to connect the exhaust opening on the hood to the d above. Use duct tape to make all joints secure and air tight.

9.Slide the inner duct cover up 2 inches before sliding the entire duct cover on Refer to Figure 13.

Figure 12

10.Adjust the height of the inner duct cover to the duct cover-mounting bracket. inner duct cover with two (4x8 mm) screws (provided) as shown in Figure 14.

11.Fasten outer duct cover to plastic plate on the hood with four (4x8 mm) screw

9