Calibration Utility for MACINTOSH
2–18 September 1997 Part No. 1H9659
Selecting a Starting Point for the Calibration Document
This section describes how to select a starting point (base file) for the
calibration document. There are three ways to access a base file:
Read Current Table from Printer
—uses the printer’s current table (refer
to “Using the Printer’s Current Calibration Table as the Starting Point”
on this page).
Use Printer’s Default Table
—uses the printer’s default table (refer to
“Using the Printer’s Default Calibration Table as the Starting Point”
on page 2–20).
Copy Table from File
—uses a previously created and saved calibration
table (refer to “Using an Existing Calibration Table as the Starting Point”
on page 2–21).
Using the Printer’s Current Calibration Table as the Starting Point
1. Select the
Read Current Table from Printer
radio button in the
Starting
Point
box.
2. Click on the
OK
button.