5
Introduction
This document contains information describing the KODAK PROFESSIONAL RFS 3600
Film Scanner (RFS 3600) version 2.10 software. This software package includes a
MICROSOFT WINDOWS TWAIN Data Source and a MACINTOSH Acquire Module;
these two items will be referred to as the Host Software. Your RFS 3600 must have
firmware version 1.34 installed for this Host Software to work properly. This document
discusses the new features and layout of the version 2.10 Host Software, as well as all
enhancements created since the original version 1.00 Host Software. For complete RFS
3600 information, refer to the User’s Manual on your original Host Software CD. Or, you
may obtain a copy of the User’s Manual from www.kodak.com.
With respect to version 1.20 Host Software, this version of software has several user
interface changes and enhancements. Also, the host computer system requirements
have been updated.
If you are a new RFS 3600 owner or this is the first time you are operating the RFS 3600
on a specific PC or MACINTOSH, you must install the software first! Do not connect
the film scanner to your computer and turn it on until you have installed the Host Software
and turned off your computer. If your computer “finds” or “sees” the film scanner and there
is no installed software to interface to it, you will not be able to use the scanner.
The screen shots seen in this document were captured from the MICROSOFT
WINDOWS TWAIN Data Source display. The screens seen in the MACINTOSH Acquire
Module are very similar.
System Requirements

MICROSOFT WINDOWS

The KODAK PROFESSIONAL RFS 3600 TWAIN Data Source is supported on
MICROSOFT’S 32-bit WINDOWS/Intel x86 or compatible PCs that meet or exceed the
following minimum system requirements:
1) 300 MHz Pentium
2) 128 MB of RAM
3) 200 MB of free disk space
4) ADOBE PHOTOSHOP 5.0, 5.5, 6.0, ADOBE PHOTOSHOP 5.0 LE or Adobe
Elements 1.0. This Host Software Version has not been tested on ADOBE
PHOTOSHOP 7.
5) 800x600Screen area, 16-bit color display (higher color setting recommended)