Purge Mode |
|
|
|
|
| Increases Flow | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
On/Off | Decreases Flow |
Operating Instructions
IMPORTANT! This product contains an automatic water purge mode that turns the blower on for two minutes about 30 minutes after the unit is turned off and drained.
NOTE: The water temperature in the bath should never exceed 104°F (40°C).
Close the drain, then fill the bath at least 4” (102 mm) above the top of the highest airjet.
Use your hand to test the water temperature for comfort and safety, then carefully enter the bath. Press the ″On/Off″ icon to turn the blower on at medium speed.
Press the ″Up″ or ″Down″ arrow icons to increase or decrease the air flow.
NOTE: The blower will turn off automatically following 20 minutes of operation, and can be immediately restarted if desired.
Press the ″On/Off″ icon a second time to turn off the blower.
Carefully exit and drain the bath.
Press the ″Purge Mode″ icon to blow remaining water from the air channels. The blower will turn on for two minutes and then turn off automatically.
NOTE: About 30 minutes after the blower motor stops, a
NOTE: If the bath does not function properly, refer to the ″Troubleshooting″ section.
Care and Cleaning
Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances could block the airjets.
Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning solutions can damage the bath surface.
Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can damage the bath surface.
Wipe out your acrylic bath with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not wax areas where you walk or stand.
Kohler Co. | 11 |
