INSTALLATION
Before you Begin
1.Turn off the water supply.
2.Make sure that the Watertile showerhead is installed by a competent installer.
3.Before installation carefully inspect the new fixture for any signs of damage.
4.Kohler Co. reserves the right to make revisions in the design of products without notice.
Install the Pipe and Elbow
1.Install the water supply pipes.
2.Install the wall mount elbow to the end of the water supply pipe at the shower head installation location.
Note! The wall mount elbow, wall plugs and fixing screws are not supplied with the product. The installer should use an appropriate wall fixing arrangement to suit the wall type or surface.
Elbow | G ½” |
41 mm Max. 
29 mm
Finished
Wall
Nipple
3.Mark the position of the Wall Mount Elbow. For solid walls drill the wall Mount Elbow holes with a 7mm diameter drill and insert the wall plugs (Supplied). For other types of wall structure alternative fixing may be required (Not supplied)
Cutout Ø 76 mm
4.Fix the Wall Mount Elbow to a solid wall or to a frame mounting using the fixing Screws supplied.
5.Finish the wall leaving a Ø76mm cutout.
6.Temporarily install the Elbow to the nipple. Do not use any sealant.
7.Make sure that the nipple extends 29mm from the finished wall. If necessary cut the long leg of the nipple to the required length
8.Apply thread sealant to the long leg of the Nipple and install it into the Elbow
9.Run water through the system to flush out any dirt or debris.
3 |
