1/16" | Bath |
| |
(2 mm) |
|
Tile Brick |
Approved
Tile Backing
Whirlpool may be installed next to the wall or as an island installation.
|
| Typical | |
Tile | Brick | access | |
panel | |||
| |||
Approved |
| Install an access panel to allow | |
Tile Backing | the pump to be serviced. |
1. Prepare the Site
Concrete Construction
NOTICE: Adequate floor support must be provided. Consult the
CAUTION: Risk of product damage. Do not support the whirlpool by the rim.
Make sure the flooring offers adequate support for your whirlpool, and verify that the subfloor is flat and level.
This whirlpool may be installed next to the wall or in an island installation. An island installation requires a four side surround. In both instances, make sure the deck is supported by brick or concrete.
Install an access panel to allow the pump to be serviced.
Construct brick or concrete supports.
Provide a 1/16″ (2 mm) gap between the whirlpool rim and the concrete or brick framing. Frame the floor, or construct a frame for a raised installation, in accordance with the
Position the plumbing according to the
Kohler Co. | 5 |