Kohler K-3394 warranty Before You Begin, How To Use These Instructions, Product Requirements

SAN RAPHAEL PRESSURE LITE

￿VITREOUS CHINA SIPHON JET TOILET

BEFORE YOU BEGIN

HOW TO USE THESE INSTRUCTIONS

Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation sequences. Follow the sections that pertain to your particular installation. This will help you avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.

All information in this manual is based on the latest product information available at the time of publication. Kohler Co. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice.

These instructions contain important care, cleaning, and warranty information ± please leave for the consumer￿

INSTALLER HAZARD NOTIFICATION PRODUCT PROPERTIES

WARNING: Risk of injury or water damage. Contents of reservoir under pressure can cause severe injury. Do not open or service before reading installation instructions or service instructions. Turn off water supply and flush unit to release pressure before attempting any service.

CAUTION: Risk of product damage. Do not use

any oils or lubricants on the Pressure Lite system.

CAUTION: Risk of product damage. The fittings in this toilet require no adjustment. The fittings in this toilet are preset. Any adjustment or modifications of the product are not normal usage and void the

warranty.

WARNING: Risk of injury or product damage.

Handle vitreous china products very carefully. Vitreous china can break and chip if you overtighten bolts and nuts.

NOTICE: ￿f ￿￿e ￿e￿ ￿￿i￿e￿ i￿ ￿￿￿ i￿￿￿￿￿￿e￿ i￿￿e￿i￿￿e￿￿￿ ￿e￿￿￿￿￿￿i￿￿ ￿￿￿ff ￿ ￿￿￿ i￿ ￿￿e ￿￿￿￿e￿ f￿￿￿￿e￿Follow all local plumbing and electrical codes.

￿Vitreous china siphon jet toilet.

￿Pressure Lite system.

￿Water depth from rim is 5-3/4º.

￿2-1/4º passageway.

￿For roughing-in and overall dimensions, See

Fig. #3 .

￿Fixture dimensions are nominal and conform to

tolerances by ANSI/ASME standards (A112.19.2).

PRODUCT REQUIREMENTS

￿The supply stop must be 2-5/8º above floor-line and 7-3/4º left of the closet flange centerline.

￿Since all toilets do not have the same supply rough-in, you may have to change the location of the supply stop to install this toilet.

￿Closet flange must be 12º on-center from wall.

￿Seat post holes are on 5-1/2º centers.

￿For most satisfactory operation, the toilet requires 20 p.s.i. static pressure at the supply stop. Maximum static pressure is not to exceed 80 p.s.i.

ORDERING INFORMATION

Toilet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . K-3394

When specified:

3/8º supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . K-7637 Floor bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21401

NOTE: For service parts ordering information, see the separate Service Parts document enclosed with the product.

113362-2-EA(9532) Copyright ￿1995 Kohler Co.