MATERIALS REQUIRED | TOOLS REQUIRED | ||
S Supply stop (3/8º recommended) | S | 10º adjustable wrench | |
S | Closet flange | S | 12º pipe wrench |
S Toilet gasket (wax seal) | S | Tubing cutter | |
S Toilet | S | Hacksaw | |
S | Toilet supply tubing | S | Level |
|
| S | Putty knife |
|
| S | Metal file |
|
| S | Tape measure |
|
| S | Screwdriver |
NOTE: Site preparation may require additional tools.
SITE PREPARATION
REMOVE EXISTING TOILET
NOTICE: Carefully inspect the new fixture for any sign of damage before removing the existing toilet. If any damage to the vitreous china or Pressure Lite system components is discovered, stop the installation and call your dealer for assistance.
Inspect the complete toilet to ensure that the:
SComponents and outlet manifold are attached securely.
STrip lever and piston actuation arm move freely.
SReservoir is securely mounted.
SVitreous china is not damaged.
Turn off the water supply.
Flush the toilet, and sponge out the remaining water from the tank and bowl.
Disconnect the supply stop, and remove the existing tank and bowl.
Remove the old gasket from the floor and closet flange with a putty knife.
Remove the old
NOTICE: If the new toilet is not installed immediately temporarily stuff a rag in the closet flange
Closet Flange
Fig. #1
2 | Kohler Co., Kohler, WI | |
|