Kohler Thermostatic Electric Shower manual Shower Tray

Avoid layouts where the shower hose will be sharply kinked. This may reduce the life of the hose.

A Hose Retaining Ring is supplied to prevent the handset from dropping below the spill-over level of the bath or shower tray, which

could lead to contamination from back-siphoning. The supplied Hose Retaining Ring should meet the majority of user requirements for shower installations with flexible outlet fittings. However, there will be occasions when it will not provide a suitable solution. In these instances an outlet double checkvalve, e.g. a Mira DCV-H, must be fitted. This

will increase the required supply pressure typically by 0.1 bar (see section “Accessories”).

Supply pipework must be flushed to clear debris before connecting to the appliance.

To avoid damage to the case when soldered fittings are used, pre-solder the pipework and fittings before connecting them to the inlet connector assembly. Refrain from applying excessive force when making any connections. Always provide mechanical support when making the plumbing connections.

The appliance is fitted with a brass inlet compression assembly for connecting to a 15mm supply pipe from the top, bottom or back. Double checkvalves, if fitted in the inlet supply to the appliance, can cause a pressure build-up, which could exceed the maximum static inlet pressure and damage the appliance.

Minimum 200mm from

ceilingConvenient height for all the family

Fixed to finished wall surface

Isolating Valve	Hose Retaining Ring
	25 mm Min
Avoid Sharp Kinks
Bath	Shower Tray