t
4.Operation
This section applies when the device has
been connected as described in chapter 3:
4.1 Switching the device on/off
The device is equipped with a FUNCTION sliding switch for all three modes:
The device is switched on and is consu- ming electricity when the switch is switched to …
•"Radio" for radio mode
•"CD" for CD mode.
The device is switched off when the switch is switched to …
position ...
•"TAPE/POWER OFF". This also the position for tape mode. In this position, the device consumes near to no electrici- ty, as long as none of the tape operating keys are pressed.
4.2 Adjusting the volume
Turn the volume control clockwise (lou- der) - or anti clockwise (quieter).
4.3 Bass-booster function
Use the BASS BOOST switch to activa- te or deactivate the Bass booster func- tion.
5.Radio mode
Select "Radio" on the FUNCTION sliding
switch.
5.1 Channel search
Chose a reception bandwidth. By pres- sing the button BAND you can switch between ...
•"FM" for VHF reception or
•"MW(AM)" for med. wave reception.
To search the bandwidth press the button ...
TUNING | , to search forwards or |
TUNING | , to search backwards over |
the entire reception range.
If you apply pressure to the buttons for lon- ger than a second the device will start an automatic channel search. As soon as a channel with sufficient reception quality has been found, the automatic search stops immediately.
Tip: When in VHF reception (FM) mode, you will achieve better reception quality by put- ting the antenna at an angle. Then turn the antenna until the best reception is found. For medium wave (AM) reception, the devi- ce uses the internal antenna. Turn the entire appliance until you achieve the best recepti- on result.
5.2 Mono/Stereo
When a program is broadcast on the VHF range in stereo, ST" is displayed on the devi- ce, while MONO". appears for Mono broad- casts. Should the stereo reception crackle due to bad reception …
press the ST/MONO button to switch between the two modes.
5.3 Storing a channel
You can store a total of 15 channels. When you have found a channel you would like to store ...
press MEMORY . The display shows the number of the first memory position, and the "MEMORY" indicator flashes.
You can now browse through the memory positions by pressing the
6
