Operation / Cleaning
The charge indicator T shows red to indicate that the device is positioned correctly in the cradle and that the charging cycle has started. Note: Ensure that the On/Off switch Y is set to Off before starting with the charging cycle.
Important:
Only return the device to the charging
station I if a single light diode of the battery’s charge indicator R lights up.
Important advice about the battery:
In the event that your battery is defective, please contact our Service Centre directly. The service centre for your country is shown on the enclosed guarantee card.
Please do not send in the whole device. Just send the defective battery.
Remove the batteries as shown in pic. A.
Summary
Note: Always make sure that the dust filter W is installed before you use the appliance.
1.To open the front nozzle Q press the dust container release button E and remove the front nozzle Q. Check that the dust filter is installed and slide the front nozzle Q back into place.
2.If you need to use the crevice tool P or the small brush {, they can be inserted into the nozzle opening Q.
Use
1.Remove the vacuum cleaner from the charging station I.
2.To operate the appliance, slide the On/off switch Y into the On position.
3.After use slide the On/off switch Y into the Off position.
4.The small brush { and the crevice tool P are used to clean narrow difficult to reach places.
5.If all the four LEDs in the battery charge indicator light up, then the batteries are fully charged. The fewer LED indicators light up, the lower is the remaining battery capacity.
Important:
If, during operation of the appliance, only one LED lights up, then this shows that the battery capacity is low. In this event, the batteries should be recharged.
Cleaning
Replacing and cleaning the dust filter
To obtain the best performance from your vacuum cleaner, empty the dust container Q and clean the dust filter W after every use.
1.To open the front nozzle Q, press the dust container release button E and remove the dust container Q.
2.Take out the dust filter W.
3.Empty the dust container Q.
4.Rinse the dust filter W in cold water and wait until it is completely dry again before replac- ing it into the dust container Q.
8 GB / IRL
