Empty the sawdust collection bag regularly. Open the zip fastener to empty the bag.
LUnlocking and switching the machine on and off
jUnlock the machine by pushing the safety lever E to the right.
Switching on:
jPress the On / Off switch D and keep it pressed.
Note: There is a delay in the machine starting up 
.
Switching off:
jRelease the On / Off switch D.
jSecure the machine again by moving the saw motor unit Q downwards and pressing the transport lock o to the left.
LSwitching the laser on and off and adjusting it
Avoiding harm from the laser beam!
The laser beam indicates the cutting line of the saw blade. Align the marks on your workpiece with the track of the laser beam.
Switching on:
jPress the laser On / Off switch i into position I.
Switching off:
jPress the laser On / Off switch i into position 0.
Adjusting the laser beam:
jTurn the laser setting screw H to adjust the laser beam.
LSetting the speed
You can
Operation
Increasing speed:
jTurn the rotation speed selector wheel F towards marking 6 or in the + direction (6= highest speed).
Reducing speed:
jTurn the rotation speed selector wheel F towards marking 1 or in the – direction (1= lowest speed).
LTransporting the machine
jBefore you transport the machine always lock the transport restraint by engaging the transport lock o with the saw motor unit Q lowered. When you carry the machine always hold it by the base.
LAttaching the laminate cutting attachment and cutting laminate
The patented laminate cutting attachment { allows you to cut laminate to your required lengths quickly and cleanly. Note that the laminate cutting attach- ment { is designed exclusively for laminate and
a material width of up to 20 cm. It is suitable for almost all types of commercially available laminate floor coverings.
jLoosen the two stop plate q setting screws using the supplied 6 mm Allen key (d) and re- move the stop plate.
jInsert in its place the laminate cutting attach- ment { and screw it to the saw table T.
jPlace the laminate flush against the edge of the stop of the laminate cutting attachment {.
LMitre cuts – turning the saw table
jLoosen the setting knob for saw table O. Press the mitre angle stop I and turn the saw table T using the saw table setting knob O to the left or right into the desired position. Release the mitre angle stop I again and tighten the saw table setting knob O.
GB/IE
11
