DIOPTER ADJUSTMENT

The EVF has a built-in diopter that can be adjusted between –3.0 to +1.0. While looking through the EVF, turn the diopter-adjustment dial until the viewfinder focus frame is sharp.

INSTALLING THE MONITOR PROTECTION PANEL

Install the monitor protection panel by placing the top of the panel at the top of the monitor frame on the camera and lower panel until it clicks into place at the bottom.

To remove the panel, lift from the bottom.

20Getting up and running

CHARGING THE BATTERY

Before the camera can be used, the lithium-ion battery must be charged. Before charging the battery, read the safety warnings on page 4 of this manual. Only recharge the battery with the supplied battery charger. The battery should be recharged before each shooting session. See page 142 for battery care and storage.

Plug the power cord into the back of the charger unit (1). Plug the other end of the cord into a live household outlet. The included AC cord is designed for the current of the sales region. Only use the cord in the region it was purchased. For more on the AC cable, see page 114.

With the battery contacts toward the charger, align the channels on the bottom of the battery with the tabs on the charger unit. Slide the battery into the unit.

The indicator lamp (2) glows to show the battery is charging. The lamp goes out when the battery is charged. Charging time is approximately 150 minutes.

Slide and lift the battery to remove it from the charger. Unplug the power cord

from the outlet.

21