GETTING UP AND RUNNING

INSTALLING AND REMOVING A MEMORY CARD

An SD (Secure Digital) Memory card or MultiMediaCard must be inserted for the camera to operate. If a card has not been inserted, three zeros (000) will blink on the data-panel frame counter. For more about memory cards, see page 7.

Always turn off the camera and confirm the access lamp is

not lit before inserting or removing a memory card, otherwise the card may be damaged, and data lost.

Access lamp

1

BATTERY

CARD

2

Open the battery-chamber door by sliding the door down

(1)to release the safety catch; the door should spring open.

Insert the memory card all the way into the card slot and then release(2). The card should catch in the slot.

•Insert the card so the face is toward the front of the camera. Always push the card in straight, never at an angle. Never force the card. If the card does not fit, check that it is orientated correctly.

•If a MultiMediaCard is inserted incorrectly, it will lock, but the card chamber door will not close.

3

To eject a memory card, press the card into the slot and

release (3). The card can now be pulled out.

BATTERY

CARD

4

Close the battery-chamber door and slide it up (4) to engage the safety catch.

ATTACHING THE HAND STRAP

1

2

Pass the small loop through the strap eyelet on the body (1).

Pass the other end of the strap through the small loop and tighten (2).

Always keep the strap around your wrist in the event that the camera is accidentally dropped.

12