2165_E.qxd 03.2.10 2:06 PM Page 53

2.Wait until both flash units are fully charged.

•When the shutter-release button is pressed partway down, the viewfinder flash signal will show the status of the built-in flash.

•When the accessory flash is charged, the AF illuminator on the front blinks, and the flash signal on the rear of the unit glows.

3.Press the subject program button to test fire the wireless/ remote

flash.

• If the accessory flash does not fire, change its position.

4.When both flash units are fully charged, press the shutter- release button all the way down to take the picture.

•If the exposure from the accessory flash was sufficient for the subject, the flash signal on the flash unit will glow.

Canceling Wireless/ Remote Flash Mode

1. Attach the accessory flash to the camera.

2. Press the flash mode button on the camera until WL no longer appears in the data panel.

• Turning off the camera with the accessory flash attached also cancels wireless flash.

If the flash is not attached, the wireless/remote function will not be canceled on the flash unit. Refer to the

flash’s instruction manual to cancel the function.

53