PICTBRIDGE

Confirm the transfer-mode option in section 4 of the setup menu is set to PictBridge. Turn on the PictBridge compatible printer. Connect the cradle to the printer using the USB cable; it is recommended to plug in the cradle to power the camera. The larger plug on the cable is connected to the printer. The smaller plug of the cable is inserted into the cradle terminal with the arrow mark facing the back of the cradle. Insert the plug in straight, never at an angle. Place the camera in the cradle and turn it on; the PictBridge screen is displayed automati- cally.

No. of prints:

7

Print size:

Printer setup

Layout:

Printer setup

Print quality:

Printer setup

Data print:

Printer setup

:start

 

The number of prints in the print run are displayed as well as the print parameters selected with the menu. See the menu navigation section for more information (p. 96). Press the center button of the controller to begin printing, or press the menu button to return to the PictBridge screen. A maximum number of fifty images can be printed.

Printing finished.

Individual still images can be selected for printing on the

Video output

 

Transfer mode

Data storage

PictBridge screen. For other printing options, see the menu navi-

Firmware ver.

PictBridge

gation section on page 96.

 

Total number of prints

Use the left/right keys of the controller to display

 

 

Number of copies

 

 

the image to be printed.

 

 

 

 

 

 

 

 

Press the up key to select the number of copies

 

 

 

to be printed. To deselect an image for printing,

 

 

 

press the down key until the number of copies

 

 

 

reaches zero.

 

 

 

 

 

Repeat the previous steps until all the images to

 

 

 

be printed are selected. Press the center button

:move

:select

:print

of the controller to continue.

 

 

 

 

94

Data-transfer mode

 

 

 

Once printing begins, the operation can be canceled by pressing the

center of the controller. The printing-finished message indicates the endOK of the operation; turn the camera off to end the routine.

NOTES ON PRINTING ERRORS

If the battery is exhausted before the print run is complete, printing is canceled. Use a fully-charged battery or plug in the cradle to power the camera. When using the power cord, connect the power cord before attaching cables or camera. When disconnecting, unplug the power cord last.

If a minor problem occurs during printing, such as the paper runs out, follow the procedure recommended for the printer; no action is required for the camera. If a major printer error occurs, press the center button of the controller to end the routine. Refer to the printer manual for the correct procedure for the printer problem. Check the printer settings before starting again and deselect the images that were printed.

95