
5. REVERB/DELAY [REV/DELAY]
This effect has a total of 7 effects including various reverb, delay and echoverb effects. The reverb effects provide spacial depth to a sound by simulating the ambience and reverberation characteristics of natural locations such as a concert hall or a room. The delay effect provides repeated echo reflections to a sound. The echoverb effect Is a combination of reverb and delay
Parameters:
A | MODE (MODE) | 1 HALL REVERB | |
|
|
| 2 ENSEMBLE HALL REVERB |
|
|
| 3 ROOM REVERB |
|
|
| 4 PLATE REVERB |
|
|
| 5 LIVE STAGE REVERB |
|
|
| 6 ECHOVERB |
|
|
| 7 DELAY |
|
|
|
|
B | TIME | Delay time between direct sound and effect | |
| (DELAY TIME) | output (Set in 100 msec steps) Delay time | |
|
|
| cannot be set in Mode 1 - Mode 5 |
|
|
|
|
C | FINE | Delay time between direct sound and effect | |
| (DELAY TIME FINE) |
| output (Set in 10 msec steps) Delay time |
|
|
| cannot be set in Mode 1 - Mode 5 |
|
|
|
|
D | FBACK | Amount of feedback The larger this value ihe | |
| (FEED BACK) |
| more times the delay sound is repeated This |
|
|
| value cannot be set in Mode 1- Mode 5 |
E | MIX | Balance between effect sound and direct | |
| (MIX LEVEL) |
| output At value 15. the balance is 50/50 At |
|
|
| value 0 direct output only |
|
|
|
|
6. [UTILITY]
This controls the master volume of each effect program and the threshold level for the noise reduction (NR) system.
Parameters:
D | NR LEVEL | The larger this value, the higher the amount of | |
| (NOISE REDUCTION |
| noise reduction. Adjust this value until no noise |
| THRESHOLD LEVEL) |
| can be heard in the sound when not playing |
|
|
| the guitar. |
|
|
|
|
E | MASTER | The larger this value, the higher the output | |
| (MASTER VOLUME) |
| level of the program. |
|
|
|
|
Re-initialise:
Hold down the write button and edit footswitch at the same time and then switch the unit power on.
An "r" appears.
The presets are now
Restore Factory defaults:
(When you have the write and edit push down the compressor pedal an "F" appears.)
Hold down the write button and edit foot switch at the same time and then switch the unit power on. Keep both down and in addition push the compressor footswitch too.
An "F" appears.
The presets are now restored to factory defaults.
See www.hgroenewegen.tmfweb.nl for more | 20 sept. 2003 | Pg 12 |
|
|
|