Configuring and Operating your PIP-300

7 Configuring and Operating your PIP-300

You can configure and operate your PIP-300via:

￿￿The front panel buttons, and/or

￿￿RS-232 serial commands transmitted by a touch screen system, PC, or other serial controller

7.1Using the Menu

Use the front panel buttons to activate the menu. The menu is displayed1 on the LCD display2 and is also superimposed on the screen2, 3.

To use the PIP-300menu, press the:

￿￿ENTER button to display the menu and accept changes

￿￿ESC button to move to the previous menu level

￿￿, ￿ arrow buttons to select the menu items, size and position the input display, adjust the numerical rates, and edit the text labeling

￿￿, ￿ arrow buttons to position the input display and to edit the text labeling

An asterisk in brackets indicates the current status on screen. For example, if the current OUTPUT SETTING is PAL, the OSD will show the asterisk in brackets alongside PAL: “PAL (*)”.

Table 3 defines the main menu items and Figure 5 illustrates the PIP-300menu guide:

 

Table 3: The PIP-300 Main Menu Items

 

 

Menu Item

Function

MODE

Select the SINGLE or the PIP mode, see section 7￿ .1.1

OSD

Activates/deactivates the OSD menu4

BORDER

Select a border around the image (applies to all channels) and select the

 

border COLOUR (WHITE or BLACK)

VIDEO SETTINGS

Adjust the CONTRAST, SATURATION and BRIGHTNESS (see section 7￿ .1.2)

INPUT SELECT

Select between: COMPOSITE video, S-VIDEO or COMPONENT video, per

 

input channel

OUTPUT STANDARD

Select between NTSC and PAL

PRESETS

Store and recall PRESETS (1 and 2), or use FACTORY DEFAULT5 settings,

 

see section 7￿ .1.3

LABELING

Display, remove and edit the text label for the input channel, see section ￿

 

7.1.4

1 The menu always displays only two lines at a time on the LCD display. Use the up/down arrow buttons to scroll up/down the menu

2 Upon powering up, the LCD briefly displays the machine’s name, and the OSD displays the firmware version 3 The menu times out after a minute, both on the LCD display and on the OSD

4 Menu still appears on the LCD display even when deactivated in the OSD

5 The machine is set to Single mode, Channel 1, default video settings and default labeling

12

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Page 15
Image 15
Kramer Electronics PIP-200xl user manual Configuring and Operating your PIP-300, Using the Menu, PIP-300 Main Menu Items