Using the
5.3 Connecting the REMOTE Connector
The contact closure remote control pins operate in a similar way to the Input selector button. Using the contact closure remote control you can select the UXGA input or cut off the inputs. To do so, temporarily connect the required input1 pin on the REMOTE terminal block connector to the GND (Ground) pin, as Figure 5 illustrates.
DO NOT connect more than one PIN to the GND PIN at the same time
To select IN 1, connect the 1 PIN to the G PIN
To select IN 2, connect the 2 PIN to the G PIN
To select IN 3, connect the 3 PIN to the G PIN
To select IN 4, connect the 4 PIN to the G PIN
To select OFF, connect the OFF PIN to the G PIN
Figure 5: Connecting the Contact Closure Remote Control PINs
1 IN1, IN 2, IN 3 IN 4, or OFF
10 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |
