Kramer Electronics user manual Using the VP-411DS 4x1 Automatic Uxga / Audio Switcher

Using the VP-411DS 4x1 Automatic UXGA / Audio Switcher

5 Using the VP-411DS 4x1 Automatic UXGA / Audio Switcher

This section describes how to:

￿Connect the VP-411DS(see section 5￿ .1)

￿Select the default master source signal (see section 5￿ .2)

￿Connect the REMOTE connector (see section 5￿ .3)

￿Connect a PC (see section 5￿ .4)

5.1Connecting the VP-411DS 4x1 Automatic UXGA / Audio Switcher

To connect your VP-411DS, as illustrated in the example in Figure 3, do the following1:

1.Connect up to four2 UXGA/AUDIO sources (for example, PC graphic cards) to the UXGA IN 15-pin HD connectors and to the AUDIO IN 3.5mm mini plug connector3.

2.Connect the UXGA OUTPUT 15-pin HD connector and the AUDIO OUTPUT 3.5mm mini plug connector to the acceptor3 (for example, a display and speakers).

3.If required, connect a local display to the UXGA IN 1 LOOP 15-pin HD connector.

4.Set the PRIORITY dipswitches (see section 5￿ .2).

5.If required, connect:

￿The contact closure remote control PINS (see section 5￿ .3)

￿PC and/or controller to the RS-232 port (see section 5￿ .4)

6.Connect the 12V DC power adapter to the power socket and connect the adapter to the mains electricity.

1 Switch OFF the power on each device before connecting it to your VP-411DS. After connecting your VP-411DS, switch on its power and then switch on the power on each device

2 You do not have to connect all the inputs

3 Audio connections are not shown in Figure 3

7