Kramer Electronics VS-88HN Upgrading the Firmware, Control Configuration via the Ethernet Port

Figure 8: Internet Protocol Properties Window

7.Click OK.

8.Click Close.

6.7.2Connecting the Ethernet Port via a Network Hub or Switch

You can connect the Ethernet port of the VS-88HNto the Ethernet port on a network hub or using a straight-through cable with RJ-45 connectors.

6.7.3Control Configuration via the Ethernet Port

To control several units via Ethernet, connect the Master unit (Device 1) via the Ethernet port to the Ethernet port of your PC. Use your PC provide initial configuration of the settings (see Section 6.4).

6.8Upgrading the Firmware

For instructions on upgrading the firmware see “Upgrading the VS-88HNFirmware Using the STC Software”.

VS-88HN - Operating the VS-88HN 8x8 HDMI Matrix Switcher 19